6. HOW TO REPLACE THE LITHIUM BATTERY
(PROCEDURE)
1. Remove the Power Flex. from Rear Case Unit. (Refer to Disassembly
Procedures.)
2. Unsolder the Lithium Battery “ML920S” and then replace the new one.
(See
Fig. B1 .)
Fig. B1
Note:
The lithium battery is a critical component. (Type No.: CR2025 Manufactured by Panasonic.)
It must never be subjected to excessive heat or discharge.
It must therefore only be fitted in equipment designed specifically for its use.
Replacement batteries must be of the same type and manufacture.
They must be fitted in the same manner and location as the original battery, with the correct polarity
contacts observed.
11
www.freeservicemanuals.info
To Next Page
Loading...
