Before Use
-15-
7) [OTHER FUNCTIONS2]
Other Functions 2 Sub-Menu
[DEMO MODE]
Demonstration Mode
≥If no operation takes place for approximately
10 minutes after the AC Adaptor was connected
to the Movie Camera and the [OFF/ON/MODE]
Switch was turned to [ON] without inserting a
Cassette, the Movie Camera is automatically
set to Demonstration Mode for introducing its
functions. If any button is pressed or operated,
the Demonstration Mode is cancelled. The
Demonstration Mode can be started by setting
[DEMO MODE] to [ON] and by exiting the
Menu. To terminate the Demonstration Mode,
insert a Cassette or set the [DEMO MODE] to
[OFF].
[INITIAL SET]
Initial Setting Mode
-37-
ª [VCR FUNCTIONS]
VCR Mode Main-Menu
1) [PLAYBACK FUNCTIONS]
Playback Functions Sub-Menu
[BLANK SEARCH]
Blank Search
-30-
[SEARCH]
Index Search Mode
-30-
[12bit AUDIO]
Audio Selector
-34-
[AUDIO OUT]
Audio Output Mode
-41-
[RETURN]
Returning to the Main-Menu
2) [DIGITAL EFFECT]
Playback Digital Effect Functions Sub-Menu
[EFFECT]
Digital Effect On/Off
-31-
[EFFECT SELECT]
Digital Effect Selection
-31-
3) [MULTI-PICTURES]
Multi-Picture Mode Sub-Menu
[SCAN MODE]
Multi-Picture Mode
-32-
[SPEED]
Strobe Multi-Picture Speed
-32-
[SWING]
Swing Mode
-32-
PRESS MENU TO EXIT
2.
DIGITAL EFFECT
3.
MULTI-PICTURES
4.
RECORDING SETUP
5.
DISPLAY SETUP
6.
OTHER FUNCTIONS
1.
PLAYBACK FUNCTIONS
VCR FUNCTIONS
4) [RECORDING SETUP]
Recording Setup Sub-Menu
[REC SPEED]
Recording Speed Mode
-16-
[AUDIO REC]
Audio Recording Mode
-16-
5) [DISPLAY SETUP]
Display Setup Sub-Menu
≥All of the items on the [DISPLAY SETUP]
Sub-Menu are the same as those on the
[DISPLAY SETUP] Sub-Menu of the
[CAMERA FUNCTIONS] Main-Menu.
6) [OTHER FUNCTIONS]
Other Functions Sub-Menu
[REMOTE]
Remote Controller Mode
-9-
[CLOCK SET]
Date and Time Setting
-15-
Setting Date and Time
Since the internal clock of the Movie Camera has
a slight imprecision, make sure to check the time
before recording.
1 Set [CAMERA FUNCTIONS] >>
[OTHER FUNCTIONS1] >> [CLOCK SET] >>
[YES].
Or set [VCR FUNCTIONS] >>
[OTHER FUNCTIONS] >> [CLOCK SET] >>
[YES].
2 Press the [PUSH] Dial (32) to select [YEAR],
[MONTH], [DAY], [HOUR] or [MIN.] and turn
to set it to a desired value.
≥Year will cycle in the order shown below.
2000, 2001, ..., 2089, 2000, ...
3 Press the [MENU] Button (40) to finish
setting the date and time.
≥The clock operation starts from [00] second.
≥The Menu will disappear when the [MENU]
Button is pressed again.
≥If the built-in battery is weak, the [0] Indication
flashes. In this case, charge the built-in battery.
≥The clock employs the 24-hour system.
M
E
N
U
PUSH
MF/VOL/JOG
WB/SHUTTER/IRIS/
(40) (32)
CLOCK SET
PRESS MENU TO RETURN
YEAR 2003
MONTH 10
DAY 08
HOUR 14
MIN. 30
30B-ENG.book 15 ページ ２００３年１月２３日 木曜日 午後８時４６分
To Next Page
Loading...
