Panasonic NV-GS10 - VCR Mode; Playback and Scene Finding

VCR Mode
-28-
VCR Mode
Playing Back
The recorded scene can be played back
immediately after the recording.
1 Rotate the [OFF/ON/MODE] Switch (37) and
set the Movie Camera to the VCR Mode.
≥The [VCR] Lamp
(39) lights up.
2 Press the [6] Button (3) to rewind the
tape.
≥Rewind the tape to the point where you want
to start playback.
≥When the tape reaches the beginning,
rewinding stops automatically.
3 Press the [1] Button (4) to start playback.
≥The [!] Indication appears.
To Stop Playback
Press the [∫] Button (7).
ª Adjusting the Sound Volume
Until the [VOLUME] Indication appears, keep
pressing the [PUSH] Dial
(32). Then, turn the
[PUSH] Dial to adjust the volume. After the
adjustment, press the [PUSH] Dial to make the
[VOLUME] Indication disappear.
To adjust the volume with the Remote Controller,
press the [T] or [W] Button to display the
O
F
F
O
N
M
O
D
E
CAMERA
VCR
(37)
(39)
SEARCH
(3)
BACK
LIGHT
(4)
(7)
FADE
PUSH
MF / VOL / JOG
W.B / SHUTTER / IRIS
(32)
[VOLUME] Indication. Press the [T] Button to
increase the volume or press the [W] Button to
decrease the volume. The [VOLUME] Indication
goes off a few seconds after the adjustment is
finished.
≥The sound volume cannot be adjusted using the
Remote Controller in Playback Zoom Mode.
(
-31-)
≥If a cassette recorded with a copyright
protection signal is played back, the picture is
distorted by mosaic-like patterns.
≥For other notes concerning this item, see
-41-.
Finding a Scene You Want to Play
Back
ª Cue/Review Playback
If the [5] Button (5) or [6] Button (3) is
pressed during Playback, it turns to Cue Playback
A or Review Playback B.
≥If the Button is held continuously, it turns to Cue
Playback or Review Playback until you release
it.
ª Variable Speed Search Function
The speed of Cue Playback or Review Playback
can be varied.
1 During playback, press the [1] Button (4).
≥The [1k!] Indication appears.
SEARCH SEARCH
BACK
LIGHT
(3) (5)
A
B
BACK
LIGHT
(4)
30B-ENG.book 28 ページ ２００３年１月２３日 木曜日 午後８時４６分