Panasonic NV-VS3A - Charging the Battery

if
Charging the Battery
Charge the Battery before using it.
1 Attach the Battery.
@Align the Battery with line C1) and push it in the direction
of the arrow while holding it down.
2 Securely connect the AC Mains Lead to the AC
Adaptor and an AC Mains Socket.
The [POWER] Lamp @ lights and then the [CHARGE]
Lamp (3) flashes and charging starts.
®if the [CHARGE] Lamp @ does not flash even though
the Battery Is attached, remove the Battery and then
re-attach it.
@ Charging Lamp [CHARGE]
Flashing: During charging
Lit: The Battery can already be used to operate the
Movie Camera but is not yet fully charged.
(Approx. 30-minute battery charge)
Off: The Battery is fully charged.
@ Removing the Battery
Slide it in the opposite direction of that indicated in step 1
above.
Charge the Battery at a room temperature between 10°C and
30°C.
eWhen charging, do not connect the DC Input Lead to the AC
Adaptor.
®During recording or charging, the Battery becomes warm.
However, this is normal.
elf you charge the Battery when it is not yet discharged, the
{CHARGE] Lamp @ may flash briefly and then go out. This
indicates that the Battery is fully charged. Therefore, this is
not an indication of a malfunction.