Panasonic NV-VS3A - Motion-Sensor-Controlled Recording

STDBY
MOTION. SENSOR
REC
b>
MOTION SENSOR
St
aI Ey
oxo i \mmr —|
I
a > ful
roo0-g Oar
4 >
mo \maky By Tuo
cam @
azm—4mig mo cum & AAD
cm mg &
BOA Oo
Zo 4
ou
PRESS MENU TO © X17
Motion-Sensor-Controlled Recording
In this made, recording automatically starts when the built-in
Motion Sensor detects some movement in the picture.
1 Press the [MENU] Button.
eThe [CAMERA FUNCTIONS] Main-Menu appears.
2 Turn the [A ¥] Dial to select [CAMERA SETUP]
and then press the [SET] Button.
The [CAMERA SETUP] Sub-Menu appears.
oe
Turn the [A V] Dial to select [M.SENSOR].
>
Press the [SET] Button to select [ON].
5 Press the [MENU] Button to exit the menu.
©The Motion Sensor Function Stand-by [STDBY]
Indication appears.
Approximately 1 second after the Movie Camera's Motion
Sensor has detected movement in the picture, recording
automatically starts. Approximately 10 seconds after
movement in the picture has stopped, recording
automatically stops and the Movie Camera is in the Motion
Sensor Stand-by Mode.
@When the Movie Camera remains in the Motion Sensor
Stand-by Mode for more than 6 minutes, the Finder or LCD
Monitor turns off, and the [ (A) ] Lamp goes out to conserve
power.
When the Motion Sensor again detects movement in the
picture, recording automatically restarts after approximately
4 seconds, and the Finder or LCD Monitor turns on, and the
[CA)] Lamp lights.
Cancelling the Motion Sensor Function During Stand-by
Set [M.SENSOR] on the [CAMERA SETUP] Sub-Menu to
[OFF].
Cancelling the Motion Sensor Function During Recording
Press the Recording Start/Stop Button for 2 seconds.