Panasonic NV-VS3A - Changing Tape Counter Display Modes

==; 0:00.00
R 0:30 >
sP ve
73
=. M0:00.00
SP
@ Changing the Tape Counter indication
By changing the setting for [DISPLAY] on the [OTHER
FUNCTIONS] Sub-Menu of the [VCR FUNCTIONS] or the
[CAMERA FUNCTIONS] Main-Menu, the Counter Display
Mode can be changed in the order shown in the above
illustrations @-Q@.
Camera Mode (@)
(1) ALL: Elapsed Tape Time Indication (initial setting)
(2) MEMORY: Memory Stop Indication and Elapsed Tape
Time Indication (-> 74)
© PARTIAL: No Counter Indication
Only a few indications are displayed so that all parts of the
picture can be seen clearly, However, when you turn on
the Movie Camera, all indications initially appear for a few
seconds to inform you of the selected settings.
@\n this condition, if you switch the Movie Camera over to
the VCR Mode and then back to the Camera Mode, [ALL]
is automatically selected for the Tape Counter Indication.
@ OFF: No Counter indication
In this mode, only the Operation Mode Indications and
Warning/Alarm Indications can appear. However, when
turning on the Movie Camera, all indications appear for a
few seconds to inform you of the selected settings.
VCR Mode
@ ALL: Elapsed Tape Time Indication (initial setting)
6 MEMORY: Memory Stop Indication and Elapsed Tape
Time Indication (> 74)
© ofr: No Counter Indication
In this mode, only the Operation Mode Indications and
Warning/Alarm indications can appear.