ImportantSafeguardsandPrecautions
FOR YOUR SAFETY, READ AND
RETAIN ALL SAFETY AND OPERATING
INSTRUCTIONS. HEED ALL WARNINGS
IN THE MANUAL AND ON THE UNIT
INSTALLATION I
POWER SOURCE CAUTION
Operate only from a power source indicated on the
unit or in this manual. If necaseary, have your Electric
Utility Se_ce Company or Video Products Dealer verify
the power source in your home.
•2 POLARIZED OR GROUNDING PLUG
As a safety feature, this Video product comes with either
a poladzed power cord plug (one blade is wider than the
other), or a three-wire grounding type plug.
POLARIZED PLUG CAUTION:
This plug will only fit into an outlet one way. If you cannot
fully insert the plug, try reversing it. If it still will not fit, have
an electrician install the proper wall outlet. Do not defeat the
• safety feature by tampedng with the plug.
GROUNDING PLUG CAUTION:
This plug will only fit Into a three-hole grounding outlet. I!
necessary, have an electrician install the proper outlet. Do
not defeat the safety feature by tampedng with the plug.
POWER CORD
Make sure power cords am routed so that they are not
likely to have anything rest on them, roll over them, or be
in the way of walking traffic.
If an extension cord is used, make sure it also has either
a poladzed or grounded plug and that the cords can be
securely connected.
Frayed cords, damaged plugs, and damaged or cracked
wire insulation are hazardous and should be replaced by
a qualified service tochnlcian.
Overloaded outlets and extension cords are fire hazards
and should be avoided.
4 DO NOT BLOCK VENTILATION HOLES
Ventilation openings in the cabinet release heat
generated dudng operation. If they are blocked, heat
build-up inside the unit can cause failures that may result
in a fire hazard or heat damage to cassettes.
For protection, follow these rules:
a. Never cover ventilation slots or the unit while in usa,
or operate the unit when placed on a bed, sofa, rag,
or other soft surface.
b. Avoid built-in Installation, such as a book case or
rack, unless proper ventilation is provided.
5 AVOID EXTREMELY HOT LOCATIONS OR SUDDEN
TEMPERATURE CHANGES
Do not place the unit over or near any kind of heater or
regulator, in direct sunlight, inside a closed vehicle, etc..
Do not move the unit suddenly between areas of
extreme temperature variation.Ifthe unitis suddenly
moved from a cold place to a warm place, moisture
may condense in the unit and on the tape.
6 TO AVOID PERSONAL INJURY
• Do not place unsecuredequipma0!o0 a sloping
surface.
• Do not place thisuniton anysupport
tha_is notfirm,level,and adequately
strong.The unitcouldfallcausing
sedousinjutytoa child oradult and
damageto the unit.
• An applianceand cart combination
shouldbe moved wlthcare.
Quickstops,excessive force,and
unevensurfacesmay cause the
applia-nceand cart combinationto overturn.
• Carefullyfollowalloperatinginstructionsanduse
the manufacturersrecommendedaccassodas
when.operatingthisunitorconnecting itto any
otherequipment.
I
1
i
OUTDOOR ANTENNA INSTALLATION I
SAFE ANTENNA AND CABLE CONNECTION
If an outside antenna or cable system _ :..
isconnected to the equipment, ,EC.,*_ILlCml¢_ €e¢1
be sure the antenna or cable system I_==
ts grounded so as to provide some _ ..,. A
protection against built up static _ _,:_--,_ ..........
charges and voltage surges. _ /2"'_ L,m., ........
Section 810 of the National _ F_
Electrical Code, ANSI/NFPA 70 J -_.._.-- I J .a_,._
(in Canada, part 1 of the Canadian L _-,._tq/_ 1!,B,m_,,,_
Electdcal Coda) provides information _ _ mJ_,,,s
with respect tOproper grounding of the _ _,m=====,m
mast and supporting structure, grounding '_"--_
of the lead-in wire to an antenna discharge unit,
size of grounding conductors, location of antenna discharge unit, connection
to grounding electrodes and requirements for the grounding electrode.
KEEPANTENNA CLEAROF HIGH VOLTAGE POWERUNES
OR CIRCUITS
An outside antenna system should be located wall away from power lines,
electric light or power circuits and where it will never coma into contact with
these power sources if it should happen to fall. When installing an outside
antenna, extreme care should be taken to avoid touching power lines,
circuits or other power sources as this could be fatal. Because of the
hazards involved, antenna installation .should be left to a professional.
I USING THE VIDEO UNIT
i
If the unit has been in storage or moved to a new location,
refer first to the INSTALLATION section of these safeguards.
1 KEEP THIS VIDEO UNIT AWAY FROM WATER OR
MOISTURE OF ANY KIND.
2 IFEQUIPMENT IS EXPOSED TO RAIN, MOISTURE, OR
STRONG IMPACT, unplug the unit and have it inspected by a qualified
service technician before use.
3 DURING AN ELECTRICAL STORM
During a lightning storm, whether indoors or outdoors, or before leaving the
unit unused for extended periods of time, disconnect all equipment from the
power source as well as the antenna and cable system.
4 WHEN THE UNIT IS PLUGGED IN
• Never expose the unit to rain or water. DO NOT OPERATE if liquid has
been spilled into the unit. Immediately unplug the unit, and have it
inspected by a service technician. Fire and shock hazards can result from
electrical shorts caused by liquid contact inside.
• Never drop or push any object through openings in the unit. Soma internal
parts carry hazardous voltages and contact can cause electric shock or
fire hazard.
• Avoid placing the unit directly above or below your'IV set as this may
cause electrical interference. Keep all magnets away from electronic
equipmanL
5 USING ACCESSORIES
Use only accessodes recommended by the manufacturer to avoid dsk of
fire, shock, or other hazards.
6 CLEANING THE UNIT
Unplug the unit. Then, usa a clean, dry, chemically untreated cloth to gently
remove dust or debris. DO NOT USE cleaning fluids, aerosols, or forced air
that could over-spray, or seep into the unit and cause electrical shock.
Any substance such as wax, adhesive tape, etc. may mar the cabinet
surface. Exposure to greasy: humid, or dusty areas may adversely affect
internal parts.
I SERVICE I
1 DO NOT SERVICE THIS PRODUCT YOURSELF
If, after carefully following the detailed operating Instructions, this Video
product does not operate propedy, do not attempt to open or remove covers,
or make any adjustments not descdbed in the manual. Unplug the unit and
contact a qua,fled service technician.
2 IF REPLACEMENT PARTS ARE REQUIRED _,..
Make sure tbe ssn_se tsohnlcianuses only parts s_ bythe manufacturer,
or those having the same safety chan_edstics as the original parts. The use of
unauthorized substitutesmay result in-fire, electric shock, or other hazards.
3 HAV_ THE SERVICE TECHNICIAN PERFORM
A SAFETY CHECK
After any service or repairs to the unit, request the service technician to
conduct a thorough safety check as described in the manufactures service
literature to insure that the video unit is in safe operating condition.
3
To Next Page
Loading...
Need help?
General