Before Requesting Service
Check the following points once again if you are having trouble with your VCR.
TV program cannot be recorded...
, r
Timer recording cannot be performed...
: There is no playback picture, or the playback
)icture is noisy or contains streaks...
Special effects playback, picture may contain
some vertical jitter when using a TV with an
Automatic Vertical Hold Control...
VCR can notbe controlled...
VCR cannot be remote controlled...
ACTION and PROG bu_ons cannot be used...
Programscannotbe viewedonTV...
Video cassettecannotbe inserted...
Videocassettecannotbe removed...
Videocassetteejectswhen a recordingis started
orthe poweris tumedofffor timerrecording...
In Stopmode,the motor(CYLINDEB) continues
to rotate...
The to; of the playbackpicturewaves backand
forthexcessively...
Completely insertthe PowerPlugintoan AC outlet.
Set the POWERbutton to ON.
• Check connections between VCR, external antenna, and your TV.
• Make sure your antenna system (CABLE or TV) is correctly set.
(To Replace Channels in Memory [P.14])
• Make sure that the record tab is intact on the cassette. (P.5)
Set the recordingstart/stoptimescorrectly.(P.18)
Make surethatthe POWERbuttonis setto OFF. (P.18)
Timerrecording maynotbe performedorcontinuedifa power
interruptionof morethan1 minuteoccursbefore,orduring,a
TimerRecording,evenafterpowerisrestored.
• Selectchannel3 or4 ontheTV to matchtheChannel3/4 switch
locatedon the rearpanelof theVCR. (P.6)
• Set theVCRFI'Vselectorto =VCR."
• Checkthat channel3 or4 ofthe TV is properlytuned in.
• AdjusttheTRACKINGcontrolineitherdirection.(P.16)
Set the TV's Vertical Hold Control to "MANUAL" and then adjust it.
• Make surethat VCR LOCKissetto off. (P.22)
• Aim the Remote Control directly at the remote sensor on the
VCR.(P.10)
• Avoid all obstacles which may interfere with the signal path.
• Inspect the remote battedes for possible replacement. (P.4)
• Make sure that VCR LOCK is set to off. (P.22)
• Exposing the VCR remote sensor to direct fluorescent or outdoor
light may cause signal interference.
• Press the VCR buttonto select VCR mode. (P.33)
• Set the VCRKV selector to "TV." (P.17)
• Insert the cassette with window side up; record tab facing you.
• Completely insert the Power Plug into an AC wall outlet.
• Make sure the record tab is intact on the cassette. (P.5)
t
• To enable the quick play mechanism, the cylinder will rotate for
about 5 minutes. This reduces response time from Stop to Play
mode from Play to Rewind Search mode.
° Because the VCR playback signal is not as stable as an off-the-air
TV signal, the top of your TV screen may be bent or unstable
dudng playback. Slowly tumthe hodzontal hold control on your
TV to correct the wavy picture. If your TV does not have a :-.
horizontal hold control or adjusting the control does not help,
please contact your local"IVservice ce__nter.
If you cannot resolve the problem, please call the Customer Satisfaction Center for
product.assistance at 201-348-9090.
To locate an authorized servicenter, please call toll free 1-800-211-PANA (7262).
35
To Next Page
Loading...
Need help?
General