Panasonic Omnivision PV-V4020 User Manual

‘Important: If the remote control POWER, ACTION, PROGA/CR+, CHA/V, NUMBERED keys,
INPUT, SEARCH or ADD/DLT button does not work when pressed, press the VCR
button on the remote and try the button again.
Review, Replace or Clear Program Contents;
(Recording is not in progress)
1
Repeat
steps 1~2 on page 12.
p DT
CH SPD
n
da
Ids
2 8
10:OOP 12:OOP
02 SP
3
10
8;OOP 9:OOP
10
SP
4
su
9:OOP 10:OOP
LI LP
CANCEL:ADO/DLT KEY
SELECT 1-8:A w KEY
ENTER : ► KEY
END :PROG/ACT I ON KEY
Select program.
1) Press AT to
select number.
f-To cancel Timer Recording->.
(Recording Is in progress)
Press POWER and then STOP
within 10 seconds to cancel the
Timer recording. (The TIMER
indicator goes out on Multi
Function Display.)
To Replace program...
fsATSl/ START STOP CH
8 SAT 10:00P 12:00P 125
SP
ISELECT START DATEI
SELECT:* ▼ KEY
SET ■ .< ► KEY
END :PROG/ACTION KEY
-
1) Press ► to display.
2) Press AT ◄► t o
set new program
contents.
or
To Clear program...
P
DT
START STOP CH SPD
a
—
-;--
—: —
— —
2
8
10:OOP 12:OOP
02
SP
3 10 8: OOP
9: OOP 10 SP
4
SU
9:00P10:00P L LP
SELECT 1-8: A T KEY
ENTER : ► KEY
END :PROG/ACT I ON KEY
ADD/DLT
1) Press ADD/DLT to
clear.
End the program.
1) Press PROGA/CR+
(or ACTION) .
• If there are programs,
press POWER off.
— Important notes when using a DSS receiver —
• When recording programs via a DSS receiver, the DSS
receiver must be left on.
• When recording programs via an antenna or cable, the
DSS receiver must be turned off.
Multi Function Display
SELECT/
2 SET
:PLAY
• ▼ :STOP
3 ◄ : R E W
► :FF
4 PROG/
VCR+
4 ACTION
3 add/
DELETE
Model PV-V4520 remote Is shown here.
13

Panasonic Omnivision PV-V4020 Specifications

General

Brand	Panasonic
Model	Omnivision PV-V4020
Category	VCR
Language	English