Panasonic Omnivision PV-V4020 User Manual

‘Important: If the remote control POWER, ACTION, PROGA/CR+, CHA/V, NUMBERED keys,
INPUT, SEARCH or ADD/DLT button does not work when pressed, press the VCR
button on the remote and try the button again.
Cable Box Setup
Process of Recording
Connection
o
©saffljj)
Programming
1
Display menu.
Press ACTION.*
MENU
SET UP VCR
SET UP FEATURE
SET CLOCK
ISET UP CHANNELI
ID lOMA/ UNGUE: ENGL! SH
VCR' S OUTPUT CH:3
SELECT:* T KEY
SET : ► KEY
END :ACT I ON KEY
Select SET UP CHANNEL.
1) Press AT to
select.
2) Press ► to
display.
3 SET UP CHANNEL
ANTENNA : CABLE
AUTO SET
WEAK SIGNAL DISPLAY : OFF
ICABLE/DSS BOX SET UP|
VCR Plus+ CH SET UP
SELECT:* ▼ KEY
SET : ► KEY
END :ACT I ON KEY
Select CABLE/DSS BOX
SET UP.
1) Press AT to
select.
2) Press ► to
display.
SELECT HOOKUP
[CABLE/DSS BOX^VCR»TVl
VCR^CABLE/DSS BOX^TV
VCR^TV
SELECT:* ▼ KEY
SET : ► KEY
END :ACT I ON KEY
Select your hookup
method.
1) Press AT to
select.
2) Press ► to set.
• If CABLE/DSS BOX ► VCR ► TV,
go to step 5.
If other, press ACTION three
times and go to page 16.
SELECT HOOKUP
CABLE/DSS BOX^VCR^TV
CABLE/D SS BOX OUTPUT CH
BaEB
SELECT:* ▼ KEY
SET : ■ * > KEY
END : ACT I ON KEY
Select cable box or DSS
receiver output channel.
1) Press AT to
select,
2) Press ► to
enter.
• If necessary, refer to your Cable
Box/DSS manual.
here.
• If you are using Audio/Video jack
connections, select and set
“VIDEO OUT’ as output channel.
End setup.
Press ACTION twice.
VCR Plus+ and PlusCode
are registered trademarks of
Gemstar Development
Corporation. The VCR Plus+
system is manufactured
under license from Gemstar
Development Corporation.
V__ y
15
Timer
Recording
Using
VCR
Plus+
System

Panasonic Omnivision PV-V4020 Specifications

General

Brand	Panasonic
Model	Omnivision PV-V4020
Category	VCR
Language	English