Panasonic Omnivision PV-V4020 - Audio Mode Settings; Audio Mode for Recording; Audio Mode for Playback

When set to proper audio mode VCR can:
1) record/playback MTS stereo broadcasts (main language) in Hi-Fi stereo.
2) record/playback mono (main language) or SAP (sub language) broadcasts.
3) playback non Hi-Fi tapes in monaural.
• The selected broadcast sound is always recorded on the left and right Hi-Fi track as well as the normal
monaural track. This means tapes can be played back on Hi-Fi and non-Hi-Fi VCRs.
V
Audio Mode for Recording
1
SAP/Hi-Fi
Display audio mode.
Press SAP/ Hi-Fi.
<
-V
(( ■ S TEREO
(( ■ S AP M
MONO
• Arrow indicates selection.
Select desired mode.
Press SAP/ Hi-Fi
repeatedly (each
press within 5
seconds).
• Refer to “Receivable
Broadcast Types” on page 24.
3 Do a recording.
See page 9.
Audio Mode for Playback
a start playback.
See page 8.
S AP/Hi-F i
o
Display audio mode.
Press SAP/ Hi-Fi.
HIF{
HIFI (l
HIFI(R)
NORMAL
• Arrow indicates selection.
Select desired mode.
Press SAP/ Hi-Fi
repeatedly (each
press within 5
seconds).
• Select '‘HIFI(L7R)" or “HIFI(L)" or
“HIFI(R)” to listen to stereo
recordings in stereo sound.
Select ''NORMAL" for monaural
sound.
SAP/Hi-Fi
• Only tapes recorded in Hi-Fi stereo
will playback with true stereo sound.
Standard stereo tapes will playback
in monaural sound.
• To listen to Hi-Fi stereo playback, the
VCR AUDIO (LyR) jacks must be
connected to a stereo TV or an
external stereo amp and speakers.
(See page 24.)
• If tracking is adjusted during playback,
Hi-Fi audio may revert to normal
audio.
• Hi-Fi and normal audio playback
volume level may differ.
'J.
25
MTS
BroadcastA/HS
Hi-Fi
Stereo
System