Panasonic P2HD AG-3DP1G - P2 Cards; Inserting P2 Cards; Removing P2 Cards

30
Chapter 3 Recording and Playback
P2 Cards
Inserting P2 Cards
 NOTE
When using the camera recorder for the first time, be sure to
set the time data beforehand.
For details, refer to [Setting Date and Time of Internal Clock]
(page 28).
1
Turn on the POWER switch.
2
Open the card slot cover.
Slot cover
3
Insert P2 cards in the L (left) and R (right) P2
card slots.
• Press in the card until the eject button pops up.
Insert the card with the
logo facing up.
EJECT button
4
Push the eject button that pops up to the right.
• The L and R P2 card access LEDs indicate the
status of the corresponding P2 card.
For details, refer to [P2 Card Access LED and Status
of P2 Car
ds] (page 31).
P2 card access LED
5
Close the card slot cover.
 NO
TE
• The camera operates only when P2 cards are inserted in both
the L and R P2 card slots.
• To prevent cards from falling out, dust from entering and
reduce the risk of exposure to static electricity, close the
card slot cover before moving the camera.
• Format two P2 cards simultaneously on this camera.
Removing P2 Cards
1
Open the card slot cover.
2
Raise the eject button.
3
Then depress the eject button to release the P2
card.
Raise the eject button.
Press the raised eject button
to remove a P2 card.