Panasonic P2HD AG-3DP1G - Using a Wireless Receiver; When Using Audio Devices

88
Chapter 5 Preparation
Using a Wireless Receiver
When using the Unislot Wireless Receiver
1
Remove the lid, install the wireless receiver and
screw it down.
2
Set the AUDIO IN switch to W.L. for the audio
channels that will be recorded.
AUDIO IN Switch
• Set the menu option WIRELESS TYPE in the
AUDIO SETUP screen to DUAL for a 2-channel
wireless receiver.
When Using Audio Devices
1
Connect the audio device to the AUDIO IN jack
with the XLR cable.
2
Set the AUDIO IN switch to REAR for the
channel to which the XLR cable is connected.
3
Set the LINE/MIC selector switch on the rear
panel to LINE.
AUDIO IN switch AUDIO IN jack
LINE/MIC selector switch