Panasonic P2HD AG-3DP1G - Use of the External DC Power Supply

85
Chapter 5 Preparation
When using a V-mount type battery
1
Mount the V-mount adapter plate.
Insert the plate and slide it as shown below.
• To remove the plate, slide the release lever
downwards.
Release
lever
2
Set the battery type.
• Select the battery type listed under BATTERY
SELECT. Select the menu option BATTERY
SELECT from the setting menu BATTERY SETUP
screen.
•
When using a battery not listed under BATTERY
SELECT, select TYPE A or TYPE B and set each
item according to the battery characteristics.
For details, refer to [BATTERY SETUP Screen]
(page
117).
 NOTE
• For information about the V-mount adapter plate, please
contact the store where you purchased the camera-recorder.
• With the V-mount adapter plate installed, % (percent) values
cannot be displayed when using batteries that show the
remaining battery capacity.
Use of the External DC Power
Supply
1
Connect the external DC power supply to the
DC IN socket on the unit.
DC IN socket
DC cable
External DC
po
wer supply
2
Turn “ON” the power switch of the external DC
power supply. (If the power switch is available
on the external DC power supply)
3
Turn the camera-recorder power switch ON.