Panasonic Palmcorder PV-D308 - Copying your Tapes (dubbing)

Copying your Tapes (dubbing)
Before you begin...
e Connect the Camcorder to VCR as shown
below.
Cas
* Turn ON both units.
* Set the recording VCR's Input Signal
Selector to LINE.
Source
(Playing)
*
Set
the
Camcorder
POWER
Camcorder switch to VCR.
-
IES
x
Y
I
Insert
a
pre-recorded
tape
3
S.
RC
into the Camcorder and a blank tape
with a recording tab into your VCR.
2 Press PLAY on the Camcorder and
when you find the starting point, press
STILL.
Audio/Video 3 Press REC on your VCR and then
Out TV immediately press STILL/PAUSE. .
(To View)
VCR Buttons
VHF Connecting ===
Cable (not supplied) C C o ES a | e |
$ PAUSE/STILL STOP REW PLAY FF REC
Recording: .
VCR
EAS A press STILL on the Camcorder and
SEN press STILL/PAUSE on the VCR to
simultaneously start both units.
i Audio-E s Video 5 Press STOP on both units when
" dubbing is complete.
Audio/Video Cable Note:
(supplied) * Tapes recorded on other VCRs and
used for playback in the Camcorder
must be recorded in SP or SLP mode.
* For technical reasons, dubbing a tape
may reduce its quality.
Monitor with your TV
* Turn the TV ON and select its VCR
channel (CH3 or CH4).
e Set the VCR/TV Selector on the
recording VCR to VCR.
CAUTION:
Unauthorized exchanging and/or
copying of copyrighted recordings may
be copytight infringement.
41
U)
go.
O
o
Dd
T
©
c
=>
c
mm
O
T