Panasonic Palmcorder PV-D308 - Stand-By Quick Release

Camera Recording
Stand-by Quick Release
Whenever the Camcorder is left in RECORD/PAUSE mode for 5 minutes, it will
automatically switch to Stand-by mode to conserve energy. Activating the Stand-by
Quick Release feature allows you to release the Stand-by mode and resume recording
by simply pressing the RECORD/PAUSE button. If this feature is not activated, it is
necessary to turn the Camcorder OFF, and then back to CAMERA to start recording
again. The default setting from the factory is OFF mode.
Before you begin...
* Connect the Camcorder to a power source.
* Insert a cassette with record tab
(see page 12).
1 Set the POWER switch to CAMERA.
jS the MENU button to display
the MENU mode. Press UP A or
DOWN Y repeatedly to select
STAND-BY RELEASE
u
t
o
O
e
po]
M
=
£9
=
a
m
TALLY LAMP
i -O
ELSIS | ON
CLOCK SET
SELECT; PUSH Via KEY
SET : PUSH DISPLAY KEY
: PUSH MENU KEY
3 Press the DISPLAY button to set ON
or OFF.
ON:
You can resume recording from Stand-
by mode by pressing the RECORD/
PAUSE button.
OFF:
RECORD/ You must set the POWER switch to
PAUSE OFF, and then to CAMERA to release
the Stand-by mode.
Abres the MENU button to set your
selection and exit the Menu mode.