Panasonic PT-AE3000U

ENGLISH - 19
Basic Operation
Switching the projector on/off
J Connecting
1. Make sure the shape of the power plug and the
AC IN terminal on the back of the projector match,
then push the plug all the way in.
2. Align the side of the power cord secure lock with
the side guide rail of the AC IN terminal of the
projector and slide it in.
3. Place the latch to the latch catcher and press until
it clicks.
4. Connect the power cord to a wall outlet.
J Disconnecting
1. Unplug the power cord from the wall outlet.
2. Depress the latch and slide the cover off.
3. Slide the power cord secure lock up along the side
guide rail and remove.
4. Hold the plug and unplug the power cord from the
AC IN terminal on the back of the projector.
Power cord
Rail guide
Latch
Latch
Rail guide
NOTE:
• Do not use other than the provided power cord.
• Ensure all the input devices are connected and turned off before connecting the power cord.
• Do not force the connector as this may damage the projector and/or the power cord.
• Dirt or dust build-up around plugs may cause fire or electrical hazards.
• Switch off the power to the projector when not in use.