Panasonic PT-D5000U

Technical Information
ENGLISH - 37
Appendix
Terminals
S-VIDEO IN
1 set, Mini DIN 4p
Y: 1.0 V [p-p], C: 0.286 V [p-p], 75
Ω, compatible with S1 signal
VIDEO IN
1 set, BNC pin jack
1.0 V [p-p], 75
Ω
RGB 1 IN
1 set, BNC x 5
 RGB signal
0.7 V [p-p], 75
Ω
• G-SYNC: 1.0 V [p-p], 75 Ω
• HD/SYNC: TTL high impedance, automatic positive/negative polarity compatible
• VD: TTL high impedance, automatic positive/negative polarity compatible
 YP
BPR signal
• Y: 1.0 V [p-p] Synchronisation signal included
•P
BPR: 0.7 V [p-p], 75 Ω
RGB 2 IN
1 set of high density, D-sub 15p (female)
 RGB signal
0.7 V [p-p], 75
Ω (G-SYNC: 1.0 V [p-p], 75 Ω)
• HD/SYNC: TTL high impedance, automatic positive/negative polarity compatible
• VD: TTL high impedance, automatic positive/negative polarity compatible
 YP
BPR signal
• Y: 1.0 V [p-p] Synchronisation signal included
•P
BPR: 0.7 V [p-p], 75 Ω
DVI-D IN 1 set, DVI-D 24-pin (Single link), DVI 1.0 compatible, HDCP compatible
SERIAL 1 set, D-sub 9-pin, RS-232C compatible, computer control use
REMOTE1 1 set, M3 pin jack, wired remote control use, multiple connection use
REMOTE2 1 set, D-sub 9-pin, external control use
LAN
1 set, RJ-45, network connection use, PJLink™ compatible, 
10 Base-T/100Base-TX
SDI
1 set, BNC
SD-SDI (Y, CB, CR, 4:2:2)
• SMPTE259M: 480i, 576i
• SMPTE292M: 720/50p, 720/60p, 1 035/60i,
1 080/50i, 1 080/60i, 1 080/25p, 1 080/24p,
1 080/24sF, 1 080/30p
Cabinet Moulded plastic
Power cord length 3.0 m (9'10")
Dimensions
Width 498 mm (19- 19/32")
Height 175 mm (6 - 7/8")
Length 440 mm (17 - 5/16")
Weight
Approx. 16 kg (35.3 lbs.)
*6
Remote
control
Power supply 3 V DC (AA battery x 2)
Operating range Approx. 30 m (98'5") (when operated directly in front of signal receptor)
Weight 120 g (4.2 ozs.) (including batteries)
Dimensions
Width 51 mm (2')
Length 176 mm (6 - 29/32")
Height
22.7 mm (-7/8") (not including surface projection
parts)
Options
Ceiling bracket ET-PKD56H (High ceiling), ET-PKD55S (Low ceiling)
Projection lens ET-DLE150, ET-DLE250, ET-DLE350, ET-DLE450, ET-DLE055
Lamp unit ET-LAD60 (1 bulb), ET-LAD60W (2 bulbs)
ACF unit ET-ACF100
*1. When STANDBY MODE in PROJECTOR SETUP menu is NORMAL: Approx. 8 W
When STANDBY MODE in PROJECTOR SETUP menu is ECO: Approx. 0.2 W
*2. Measurement, measuring conditions and method of notation all comply with ISO21118 international standards.
*3. When using this projector at high elevations 1 400 - 2 700 m (4 593 - 8 858 ft) sea level, temperature will be 5 °C lower than this
higher limit.
*4. See “List of compatible signals” on page 34 for available signals.
*5. When using the ET-DLE055 lens, maximum projection size is 200 inch.
*6. Average value. Each product (inc. lens) has an individual variable in weight.