Removing/attaching the projection lens
28 - ENGLISH
Getting Started
Removing/attaching the projection lens
Perform the following steps when removing/attaching the standard zoom lens or the optional lens.
Move the lens to the home position before replacing or removing the lens. (
page 36)
Attention
z
Replace the projection lens after turning off the power of the projector.
z
Do not touch the lens signal receiver. Dust or dirt may cause defective contact.
z
Do not touch the lens surface with your bare hands.
z
B
efore attaching the projection lens, remove the dust sponge attached to the projector and the lens cover
attached to the projection lens.
z
For the ultra short-focus zoom lens (ET-DLE080), the procedure for removing/attaching the lens is different.
For details, refer to the instruction manual supplied with ET-DLE080.
Removing the projection lens
1) Turn the projection lens cover counterclockwise and remove.
(ii)
(i)
Projection lens cover
2) While pressing the lens release button, turn the projection lens counterclockwise all
the way, and remove the projection lens.
(i)
(ii)
(iii)
Projection lens
Lens release button
Attention
z
Store the removed lens where it will be free from vibration and impact.
To Next Page
Loading...
