Panasonic PT-DW830U - Connecting Terminals

Chapter 1 Preparation — About your projector
28 - ENGLISH
r Connecting terminals
1 2 3 4 5
6 7 8 9 10 11 12
1 <REMOTE 1 IN> terminal/<REMOTE 1 OUT> terminal
These are the terminals to connect the remote control for serial
control when the system uses multiple projectors.
2 <REMOTE 2 IN> terminal
This is a terminal to remotely control the projector using the
external control circuit.
3 <SERIAL IN> terminal
This is the RS-232C compatible terminal to externally control
the projector by connecting a computer.
4 <SERIAL OUT> terminal
This is a terminal to output the signal connected to the <SERIAL
IN> terminal.
5 <3D SYNC 1 IN/OUT> terminal / <3D SYNC 2 OUT> terminal
This is a terminal to input or output control signals when using
the projector in 3D systems.
6 <SDI IN> terminal
This is the terminal to input SDI signals. (Only for PT-DZ870U)
7 <VIDEO IN> terminal
This is the terminal to input video signals.
8 <RGB 1 IN> (<R/P
R
>, <G/Y>, <B/P
B
/C>, <SYNC/HD>, <VD>)
terminal
This is a terminal to input RGB signals or the YC
B
C
R
/YP
B
P
R
and
Y/C signals.
9 <RGB 2 IN> terminal
This is a terminal to input RGB signals or YC
B
C
R
/YP
B
P
R
signals.
10 <DVI-D IN> terminal
This is the terminal to input DVI-D signals.
11 <HDMI IN> terminal
This is the terminal to input HDMI signals.
12 <DIGITAL LINK/LAN> terminal
This is the LAN terminal to connect to the network. This is also
used when connecting a video signal transmission device via
the LAN terminal.
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.