To Next PageTo Next PageWhy is the 3D function not working on my Panasonic PT-DW17K2?
If the 3D function is not working on your Panasonic Projector, ensure the [3D INPUT FORMAT] setting of [3D SETTINGS] is correct. Check the 3D eyewear settings. Also, verify that the input signal is supported by the projector.
How do I get my Panasonic PT-DW17K2 Projector to display image from computer?
If your Panasonic Projector is not displaying an image from a computer, check if the cable is too long (for D-Sub cables, it should be 10 m (32'10") or shorter). Also, ensure the external video output on the laptop is set correctly; you might need to press “Fn” + “F3” or “Fn” + “F10” simultaneously, but refer to your computer's manual for specific instructions.
Why isn't my Panasonic Projector remote control working?
If the remote control for your Panasonic Projector isn't responding, check the following: Ensure the batteries aren't depleted and are correctly oriented. Make sure there are no obstructions between the remote and the projector's receiver, and that you're within the remote's effective range. Also, check if other light sources are interfering, if the [REMOTE CONTROL] setting in [CONTROL DEVICE SETUP] is set to [DISABLE], if the terminal is used for contact control, and if the ID number setting is correct.
What to do if my Panasonic PT-DW17K2 shows no image?
If your Panasonic Projector is not displaying any image, verify that all connections to external devices are correctly performed and the input selection setting is correct. Also, check if the [BRIGHTNESS] adjustment is at a minimum, the external device connected to the projector is working properly, the shutter function is in use, or the lens cover is still attached. If the power indicator is blinking in red, consult your dealer.
How to resolve a fuzzy image on my Panasonic Projector?
To fix a fuzzy image on your Panasonic Projector, first, ensure the lens focus is correctly set. Then, check if the projection distance is appropriate. Also, verify whether the lens is dirty and whether the projector is installed perpendicular to the screen.
Why is my Panasonic PT-DW17K2 image not displaying correctly?
If the image on your Panasonic Projector is not displaying correctly, verify that the [SYSTEM SELECTOR] selection is set correctly, the [RGB1 INPUT SETTING] is properly configured, there isn't a problem with the video tape or image source, and the input signal is compatible with the projector.
Why does the image in my Panasonic PT-DW17K2 3D eyewear flicker?
If the image in your 3D eyewear flickers while using your Panasonic Projector, ensure that you are within the reception range.
Why can't I control my Panasonic PT-DW17K2 Projector with Art-Net?
If you cannot control your Panasonic Projector with Art-Net, ensure the connections between the twisted-pair-cable transmitter and an external device, and between the transmitter and projector are correct. Check that [Art-Net SETUP] is set to other than [OFF]. Also, verify that [NET], [SUB NET], [UNIVERSE], and [START ADDRESS] are set correctly.
Why can't I adjust the lens shift on my Panasonic Projector?
If the lens shift cannot be adjusted on your Panasonic Projector, try performing [LENS CALIBRATION]. Also, check if the fixed-focus lens (Model No.: ET?D75LE50) is attached.
Why does my Panasonic PT-DW17K2 Projector display pale colors?
If the color on your Panasonic Projector appears pale or grayish, check if the [COLOR] and [TINT] are adjusted correctly. Also, verify that the external device connected to the projector is adjusted correctly and that the RGB cable is not damaged.
General