Panasonic PT-DZ13KU

Chapter 2 Getting Started — Setting up
ENGLISH - 31
Setting up
Installation mode
There are six ways to set up the projector. Set the [PROJECTOR SETUP] menu → [PROJECTION METHOD] (x page 108) depending
on the installation location. Set [COOLING CONDITION] (x page 109) to [AUTO]. Using the projector with [COOLING CONDITION] set
incorrectly may shorten the life of the lamp.
Mounting on the ceiling and projecting forward Setting on a desk/oor and projecting from rear
(Using the translucent screen)
Menu item Method Menu item Method
[PROJECTION METHOD] [FRONT/CEILING] [PROJECTION METHOD] [REAR/FLOOR]
[COOLING CONDITION] [CEILING SETTING] [COOLING CONDITION] [FLOOR SETTING]
Mounting on the ceiling and projecting from rear
(Using the translucent screen)
Setting on a desk/oor and projecting forward
Menu item Method Menu item Method
[PROJECTION METHOD] [REAR/CEILING] [PROJECTION METHOD] [FRONT/FLOOR]
[COOLING CONDITION] [CEILING SETTING] [COOLING CONDITION] [FLOOR SETTING]
Portrait setting and projecting from the rear
*1
(Using the translucent screen)
Portrait setting and projecting forward
*1
Menu item Method Menu item Method
[PROJECTION METHOD] [REAR/FLOOR] [PROJECTION METHOD] [FRONT/FLOOR]
[COOLING CONDITION] [PORTRAIT SETTING]
*2
[COOLING CONDITION] [PORTRAIT SETTING]
*2
*1 For the portrait setting, use the optional Replacement lamp unit (for portrait mode) (Model No.: ET-LAD320P (1 pc), ET-LAD320PW (2 pcs)).
*2 Using the optional Replacement lamp unit (for portrait mode) (Model No.: ET-LAD320P (1 pc), ET-LAD320PW (2 pcs)) will set the cooling condition
to [PORTRAIT SETTING].
Note
f In the portrait setting, the on-screen menu is displayed sideways.