Panasonic PT-EX510 - Projector Setup: Audio Balance, Speaker Output, Mute Mode

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 93
Adjusting the left to right audio balance
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [BALANCE].
4) Press qw to adjust the level.
Operation Adjustment Range of adjustment
Press w.
Increases the volume on the right.
L16 - R16
Press q.
Increases the volume on the left.
Setting audio output of the built-in speaker
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [BUILT-IN SP].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
Audio is output from the built-in speaker.
[OFF]
Audio is not output from the built-in speaker.
Note
f Audio is output from the built-in speaker even if the cable is connected to the <VARIABLE AUDIO OUT> terminal. To output audio from
external audio devices connected to the <VARIABLE AUDIO OUT> terminal and not from the built-in speaker, set [BUILT-IN SP] to [OFF].
Setting audio output in the standby mode
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [IN STANDBY MODE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Audio is not output during standby.
[ON]
Audio is output during standby.
Note
f When [STANDBY MODE] (x page 88) in [PROJECTOR SETUP] menu → [ECO MANAGEMENT] is set to [ECO], audio cannot be output
during standby.
Setting to mute mode
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [MUTE].
4) Press qw to switch the item.
f The items will switch each time you press the button.