Using WebBrowser (cont.)
E-mail set up
You can specify two email recipients.
Click [Detailed set up] → [E-mail set up] in the menu.
[MAIL SERVER]
•
ENABLE : Enable or disable email transmission.
SMTP SERVER NAME : Enter the SMTP server name.
[MAIL OPTION]
•
MAIL FROM : Enter the sender’s email address.
MEMO : Enter a description of the sender.
[TEMPERATURE WARNING SET UP]
•
MINIMUM TIME : Enter the interval for sending email.
INPUT AIR TEMPERATURE :
Select the temperature of the intake sensor
at which to send a warning message.
[E-MAIL ADDRESS]
•
E-MAIL ADDRESS : Enter the email addresses of the recipients.
MAIL CONTENTS : Change the type of message as desired.
When sending messages to mobile phones, select “SIMPLE”.
ERROR : Select ON to send email when errors occur.
LAMP RUNTIME : Select ON to send email when “at REMAIN” is reached.
INPUT AIR TEMPERATURE :
Select ON to send email when the temperature set in [TEMPERATURE WARNING SET UP] is
exceeded.
PERIODIC REPORT : Send a message with the projector status at the selected date and time.
When [submit] is clicked, the settings are applied.
Consult your system administrator on MAIL SERVER and E-MAIL ADDRESS settings.
Ping test
You can confirm if a network connection is established with Mail server,
POP server, DNS server or the like.
Click [Detailed set up] → [Ping test] in the menu.
Input IP address : Enter the IP address of the server you want to
test, and then click [Submit].
If succeeded in connection, the following display appears.
If failed in connection, the following display appears.
To Next Page
Loading...
