Panasonic PT-LB75VE - Page 52

Care and Replacement
Maintenance
52 -
E
NGLISH
$WWDFKWKHODPSXQLWFRYHUDQGWLJKWHQWKHODPSXQLWFRYHU¿[LQJVFUHZVVHFXUHO\ 5)
with a Phillips-head screwdriver.
&RQQHFWWKHPDLQVOHDGWRDPDLQVVRFNHW6)
Press the POWER button and the projection starts.7)
5HPDUNV
If
z
INITIAL START UP in the PROJECTOR SETUP menu is set to ON, the projector starts projecting when the
mains lead is connected to a mains socket. (
¨
page 41)
3UHVVWKH0(18EXWWRQWRGLVSOD\WKHPDLQPHQXDQGSUHVVŸźEXWWRQVWRVFUROOWR8)
the PROJECTOR SETUP menu.
Press the ENTER button to select the PROJECTOR SETUP menu and 9)
SUHVVŸźEXWWRQVWRVHOHFW/$035817,0(
3UHVVDQGKROGWKH(17(5EXWWRQIRUDSSUR[LPDWHO\VHFRQGV
10 )
The
z
LAMP RUNTIMEFRQ¿UPDWLRQVFUHHQLVGLVSOD\HG
LAMP RUNTIME
LAMP RUNTIME RESET.
OK
CANCEL
PRESS ANY OTHER BUTTON
PRESS BUTTON
Note
If any button other than the
z
POWER button is pressed, the LAMP RUNTIME screen disappears and the lamp
runtime is not reset. (Repeat from step 8 again).
Press the POWER button. 11 )
After the lamp goes off, projection stops and the
z
POWER button lights in red, then disconnect the mains
plug.
The lamp runtime is reset to “0”. 12 )