Panasonic PT-LC50E - Changing to 16:9 (wide) screen format; Selecting Procedure

37
Previous
screen
When a S-VIDEO/VIDEO or DTV Format (RGB, YPBPR) signals
is input, the image can be displayed in 16:9 (wide) screen by the
following procedure. This only applies for S-VIDEO/VIDEO and
DTV Format signals. The procedure below describes the on-
screen displays when the S-VIDEO signal or the VIDEO signal is
being projected.
Projection Mode
Screen
16:9
On Screen Display
Auto Lamp Off
Standard (Push ENTER)
•Front •Rear
•4:3 •16:9
•ON •OFF
•ON •OFF
•YES •NO
Function
Picture
White Balance
Video System
Function
Language
Information
•Selecting procedure
1 Press MENU to
display the menu.
2 Press or to select
“Function”, and then
ENTER to display the
screen.
3 Press or to select
“16 : 9”.
4 Press or to select
“ON” or “OFF”.
• Select “OFF” to return
the normal screen.
(This is the factory
setting.)
• Select “ON” to display
in 16:9 (wide) screen.
Changing to 16:9 (wide) screen format
Downloaded From projector-manual.com Panasonic Manuals