Chapter 1 Preparation — Precautions for use
ENGLISH - 21
f Use a torque screwdriver or Allen torque wrench to tighten the xing screws to their specied tightening torques.
Do not use electric screwdrivers or impact screwdrivers.
(Screw diameter: M6, tapping depth inside the projector: 27 mm (1‑1/16"), screw tightening torque: 4 ± 0.5 N·m)
Positions of screw holes to fix projector and
adjustable feet
Screw tightening torque: (M6) 4 ± 0.5 N·m
Adjustable feet
Embedded nut
Screw hole maximum
depth
27 (1-1/16")
10 (13/32")
Embedded nut (thread
engagement depth)
M6
27 (1-1/16")
Mount
M6
Thread engagement depth
Screw holes to fix the projector
Unit: mm
Adjustable feet
f When using two projectors stacked on each other, take a measure to prevent falling just in case. Or, use the
optional Frame (Model No.: ET‑PFD510).
f Do not stack three or more projectors.
f Do not use the projector supporting it by the top.
f Do not block the ventilation ports (intake and exhaust) of the projector.
To Next Page
Loading...
