Chapter 1 Preparation — Precautions for use
ENGLISH - 19
rCautions when setting up the projector
f The projector can be used by installing its top placed on the oor. To prevent the top surface from getting
scratched during use, it is recommended to attach about a 20 mm (25/32") square buffer material (such as
rubber cushion) on the four corners of the top surface.
Buffer material
Buffer material
Floor
f Use the adjustable feet only for the oor standing installation and for adjusting the angle. Using them for other
purposes may damage the projector.
f When installing the projector with a method other than the oor installation using the adjustable feet, top placed
on the oor, or the ceiling installation, use the ve screw holes for ceiling mount (as shown in the gure) to x
the projector to the mount.
(Screw diameter: M6, tapping depth inside the projector: 12 mm (15/32"), torque: 4 ± 0.5 N·m)
In such case, make sure that there is no clearance between the screw holes for ceiling mount on the projector
bottom and the setting surface by inserting spacers (metallic) between them.
Screw holes for ceiling mount (M6)
Adjustable feet Adjustable feet
Positions of screw holes for ceiling mount and adjustable feet
f Do not stack projectors on top of each other.
f Do not block the ventilation ports (intake and exhaust) of the projector.
To Next Page
Loading...
