43
Editing Features
Editing Features
The original sound can be replaced with
new sound using the built-in Palmcorder
microphone.
Audio Dubbing using the
Built-in Microphone
1Set POWER to VCR.
• If you have the optional Remote
Control, you can set the Palmcorder to
stop automatically at a specified point
on the tape. See “Memory-Stop
Editing” on page 44.
2Press (PLAY). Then press
(PAUSE) where you want dubbing to
begin.
3Press MENU to display the VCR mode
menu screen.
Rotate JOG KEY to select REC MODE ,
then press JOG KEY to display the
VCR REC MODE menu screen.
Rotate JOG KEY to select AUDIO-
DUB , and then press JOG KEY to
select ON.
• The Palmcorder will go to Stand By
mode, and “A.DUB” flashes in the EVF
or the LCD monitor. Go to step 4.
2PLAY
2PAUSE
3A.DUB
Before you begin
• Turn on the Palmcorder.
• Insert a pre-recorded tape to be
dubbed.
Built-in Microphone
The AUDIO-REC setting in CAMERA
MENU mode should be as follows:
• Select 12 bit if you do not want the
original sound to be completely replaced
during an audio dub.
• If you dub over a tape which has both
12 bit and 16 bit audio recordings on it,
keep in mind that the original 16 bit audio
portion will be completely replaced.
12 bit
16 bit
The original sound is recorded
on ST (Stereo) 1, and the new
sound will be recorded on ST
(Stereo) 2.
The original sound is replaced
with the new sound.
1POWER
3JOG KEY
3MENU
When using the Palmcorder only
When using the Optional Remote
Control only
3 Press A.DUB on the Remote Control.
• The Palmcorder will go to Stand By
mode, and “A.DUB” flashes in the
EVF or the LCD monitor. Go to step 4.
Optional
(Continued on next page.)
DV102.p 43-46.p65 02/03/05, 12:5743
To Next Page
Loading...
