73
PC Connection
For Windows 2000 users
3 Connect the Palmcorder to your PC (Windows) using the USB Cable (supplied).
•“CONNECT WITH PC” appears in the EVF or the LCD monitor.
• The “Found New Hardware” screen of Windows is displayed.
• When the Palmcorder and PC (with Windows 2000) are connected via USB, a
message, such as the one below, is displayed.
The following message is displayed. However, testing by the manufacturer
has confirmed functionality of this palmcorder with Windows XP/2000.
Click [Yes] and proceed.
For Windows 98SE/Me users
3 Connect the Palmcorder to your PC (Windows) using the USB Cable (supplied).
•“CONNECT WITH PC” appears in the EVF or the LCD monitor.
Note
• For extended use, the AC Adaptor should be used as a power source.
Palmcorder USB Device Driver/SD Drive
Note
• For extended use, the AC Adaptor should be used as a power source.
DV102.p 72-74.p65 02/03/05, 12:5973
To Next Page
Loading...
