Panasonic RQ-320SD - Page 28

i) FA 7 i 35 a 2 SA SASL PS BRR BE
sae SE
GR 10.7 Fi Ae AS EAL
SAAT 10.7 RE HE 400 PRR RB
xR
FERS AEE EIA (External Sweep); 5/0 ACM EOS AY 60 Hz HMMS ORE ARR ZA
S58) RAE PEE LIE (FM).
Se Boe HB).
SaaS ie: M01, AVEPEEUREL TP3 & A) MASON, TRE,
Feel PA eae PBA, (OFF). FEL,
ee BBR ETE 120~250 fK.
Hae | SRR ee ia Me
T1 GREE 1 RIE) ae eo ash A
ASRS 0.001 | ABUELHEABAS 0.001 | RANT MERE | MEARE ZEEE | T2 GRR 2 fURRER) | ee 109 Ek
EE TP2 Hi, Jk | MOE TP2 BA, Je | Goze HHSUCAREE = | T3 HUE SIME) | eng
FEAR. EGE. 90 FAHD | TP3 Wi, JERE, | TS CHIE 4 HME) | Ce sence gpg
T7 (GRSER 4 cheese) |e
SMUT 0.001 | HRMWELBIBS 0.001) KA EeE, | MBSR EE snore
MEP TP2 Bi, J | MERE TP2 Bi, JE] GOde HUSRMABE T7 (SESE 5 case SeRE aan Pee ie
FEAR.
EAR,
90
FAMED)
|
TP
BE,
ILAR
REAR,
tne
ee
(SHB
QSE15 IE)
FM RF ALIGNMENT
Output of signal generator should be no higher than necessary to obtain an output reading.
Set volume contro! to maximum. Set tone control to treble.
Set band selector switch to FM. Set AFC switch to “OFF”.
Maintain line voltage at 120~250 volts.
SIGNAL SIGNAL
GENERATOR
GENERATOR
RE
INDICATOR
ADJUSTMENT
REMARKS
COUPLING FREQUENCY
Connect to EXT FM
antenna terminal Output meter
3 through FM dummy 90 MHz 90 MHz across EXT SP L6 (FM OSC coil) Adjust for maximum
antenna. Common (400 Hz Mod.) : L4 (FM collector coil) output.
to chassis. ack:
(Refer to fig. 16)
Connect to EXT FM
BEES
nna
terminal
Output
meter
|
C19
(FM
OSC
tri
Adjust
for
maximum
| through FM dummy 106 MHz ar pages ( rimmer) | ACJ eee
antenna. Common (400 Hz Mod.) 2 ere C9 (FM collector BULB: SRee pare
: jack. trimmer) | (3) and (4).
to chassis.
(Refer to fig. 16)
Note: Three output responses will be present; proper tuning is the center frequency.
23