Panasonic RQ-V190 - Page 13

2. Tune in the station to be stored.
3. Press the memory button.
The memory indicator will flash on and off for
10 seconds.
4. During flashing, press the memory select
button to select the memory channel num¬
ber (1-4).
The memory channel number will appear and
each time the memory select button is
pressed, the memory channel number will
change from 1 to 4 in turn.
5. Press the memory button.
(Three beeps will be emitted.)
The memory indicator will light.
■ How to tune in the stored stations
1. Set the function selector to “RADIO”.
2. Release the hold state.
3. Select the mode (MODE1, MODE2).
4. Select the desired radio band using the
band/mode select button.
(Direct tuning)
5. Press one of the 1,2 or 3 buttons to receive
your desired station.
6. Adjust the volume using the volume con¬
trol.
(Memory channel tuning)
5. Press the memory select button until the
desired memory channel number appears.
6. Adjust the volume using the volume con¬
trol.
i
/
V