RQT5142
17
Recording operations
Recording CDs (Deck 2 only)
Preparation:
•Insert a CD ( page 9).
•To record from the beginning of the tape
Wind on the leader tape.
•Select the reverse mode.
Press [ DECK 2] to open the deck and
load a cassette.
Recording starts from the side facing up
Close deck by hand.
(Play direction automatically switches to
“
”
when
the deck is closed.)
Press [ TAPE/CD] to switch to CD mode.
Each time the button is pressed
TAPE CD
Press [ ] to start recording.
CD play and recording start at the same time.
The cassette stops when the CD finishes.
: Recording top side
: Recording bottom side
Deck 1 cannot be operated during recording.
To stop recording
Press [ TAPE/CD].
To pause recording
Press [ ].
Press again to resume recording.
To continue recording from another CD on the
same tape
Press [ CD OPEN/CLOSE] and insert the other CD.
Press [ ].
Recording begins from where it stopped.
To record selected tracks
Do step , then program the tracks ( Program play
steps to on page 11).
Press [ ].
To skip unwanted tracks
Press [ ] to pause recording. (The CD also pauses.)
Turn [ TIME/PRE.TUNE/CD] so the
next track you want to record is displayed.
Press [ ] to resume recording.
Recording tape
Leader tape
Insert inside the guides
Tape facing out
Lights
Recording direction
To Next Page
Loading...
