RQT5142
12
Radio operations
FM AM
The radio: manual tuning
Preparation: (when using batteries) Press [
].
Press [BAND ] to select FM or AM.
(Unit comes on when using AC power.)
Each time the button is pressed
AM FM
Press [ , REW–TUNE/ –FF]
to select a station.
“
”
is displayed during FM stereo broadcasts.
Press [–,+VOLUME] to adjust the volume.
Auto-tuning
Press and hold [ , REW–TUNE/ –FF] until
the frequency starts changing rapidly.
Stops when it finds a station. (Interference may also cause
it to stop. Start auto-tuning again if this occurs.)
To stop auto-tuning
Press [ , REW–TUNE/ –FF].
To improve reception
FM: Change the length and position of the antenna.
AM: Change the facing of the unit.
•AM reception is briefly interrupted if a tape deck is oper-
ated.
•To improve reception when using the unit in a building or
vehicle use it near a window.
If noise is excessive in FM
Remote control only
Press [FM MODE/BP] to display
“
”
.
This mode improves sound quality if reception is weak for some
reason but broadcasts are heard in monaural (“ ” goes
out).
Press [FM MODE/BP] again to cancel the mode.
Frequency
To Next Page
Loading...
