Panasonic RX-FT530 - Listening to Radio Broadcasts; Tuning and Volume Adjustment

Listening to Radio Broadcasts
Refer to EJ .
SELECTOA
Set
SELECTOR
to
RADIO.
1
cap
rors o I
at)
2 ci nD Set BAND to the desired radio
re band.
mm “FM STEREO: To receive FM stereo
broadcasts
{If you have tuned into
an FM stereo broad-
cast, the FM ST indica-
tor will fight.)
AM: To receive AM broad-
casts
elf FM stereo reception is poor, set BAND to FM. This
will reduce the noise and provide clear reception;
however, the broadcast will not be heard in stereo.
Use TUNING to tune into a de-
TUNING
3 sired broadcast.
4 a oe, Adjust VOLUME and TONE.
T) e
um MAX Low wan
The radio can be turned off by setting SELECTOR to TAPE/
ay -
Adjust the antennas E]
FM:
Pull out the telescopic antenna and adjust its length and
angle for optimum reception.
AM:
Turn the unit in the direction which gives the best results.