7
1. GENERAL
This booklet briefly outlines where and how to install the air conditioning system. Please read
over the entire set of instructions for the indoor and outdoor units and make sure all accessory
parts listed are with the system before beginning.
1-1. Tools Required for Installation
(not supplied)
1. Flathead screwdriver
2. Phillips head screwdriver
3. Knife or wire stripper
4. Tape measure
5. Carpenter’s level
6. Sabre saw or keyhole saw
7. Hacksaw
8. Core bits
9. Hammer
10. Drill
11. Tube cutter
12. Tube flaring tool
13. Torque wrench
14. Adjustable wrench
15. Reamer (for deburring)
1-2. Accessories Supplied with Unit
Part Name Figure Q’ty Remarks
Washer
8
For suspending indoor
unit from ceiling
Flare
insulator
2
For gas and liquid
tubes
Insulating
tape
2
For gas and liquid
tubes flare nuts
Drain
insulator
1 For drain hose joint
Hose band
1
For securing drain
hose
Packing
2
For drain hose joint
(hard material)
Clamper
2 For drain hose joint
Drain hose
1
For main unit + PVC
pipe joints
Clamper
2 For electrical wiring
Clamper
2
In the case of using
the Solenoid Valve
Controller (for
connecting 3WAY
VRF outdoor unit)
Filter
*
When not connecting
the air intake, be sure
to install the filter.
Screw
*
Operating
Instructions
1
Installation
Instructions
1
Short-circuit
connection
1
For vertical installation
(Located on the
back of the electrical
component box lid.)
* 1 Q’ty : Type 15, 22, 28, 36, 45, 56
2 Q’ty : Type 60, 73, 90
2 Q’ty : Type 106, 112, 140, 160
●
Use M10 for suspension bolts.
●
Field supply for suspension bolts and nuts.
01_350221_Eng.indb 7 2023/3/17 10:00:57
To Next Page
Loading...
