Panasonic SA-AK640E - Page 78

Pin
No.
Mark I/O Function
28 10DB_ATT O No Connection
29 PLL_DAT O PLL DATA
30 PLL_CLK O PLLCLK
31 REG8 - To GND resistor
32 REG7 I Region Setting 7 (MIC)/
Flash Rx
33 REG6 I Region Setting 6 (RDS)/
Flash Clock
34 REG5 O Chip Select/Flash Busy
35 REG4 I Latin Non Chip Select
36 REG3 I Region Setting 3 (Tuner)
37 REG2 I Region Setting 2 (Tuner)
38 REG1 I Region Setting 1 (Tuner)
39 MUTE_DA O Mute_DA for Digital Amp
40 MUTE_A O Audio Mute
41 EE_CS/EFP/
EPH
O EEPROM Chip Select
42 EE_CLK O EEPROM CLOCK
43 EE_DAT I/O EEPROM DATA
44 N.C. - No Connection
45 N.C. - No Connection
46 PCONT/EFP/
CS
O Main Transformer
Control Output
47 DCDET I DC Detect Input
48-49 N.C. - No Connection
50 STANDBY O Standby mode
51 N.C. - No Connection
52 HALF_1 I Deck 1 HALF
PLAYBACK INPUT
53 MODE_1 I Deck 1 MODE
PLYABACK INPUT
54 N.C. - No Connection
55 N.C. - No Connection
56 PLG1 O Deck 1 plunger control
57 PLG2 O Deck 2 plunger control
58 MTR O/I Deck motor control
(“L” for motor ON)
59 REC O/I L when record circuit is
operating
60 DECK1_H O H when DECK 1 P/B
head is selected
61 N.C. - No Connection
62 VCC - Power Supply (+5V)
63 N.C. - No Connection
64 VSS - Ground (0V)
78