5. Press cursor key to select “Enter 1D barcode by
remotecon...”, then press “OK” key.
6. “Input 1D barcode data” screen is displayed. Pressing
cursor key to select character, then pressing “OK” key to
decide and enter selected character.
If entering 64 character of barcode finished, press
“RETURN” key to finish key in, then press “OK” key to
save inputs.
• To Cancel Adjustment / Return to Settings Screen:
Press “STOP” key.
7. When the drive adjustment is completed, “Pass” is
displayed. Press “STOP” key twice, the screen is return to
Settings screen.
• If the drive adjustment is failed, “Fail” is displayed.
To Next Page
Loading...
