The radio
_J
SELECTOR
BAND _U_E MEdi€ PRESET VTUNI_^
I I I I I I I
O.
RECBd51
1 2 3
D D D
4 5 6
55D
7 8 9
Q D G'-
tl
D
ctsc
C],--
d
You can tune radio stations manually by selecting the station's
frequency.
(_ Turn [INPUT SELECTOR] to select "TUNER".
(_ Press [BAND] to select "FM" or "AMY.
(_ Press [TUNING V or A] to select the frequency.
Tuning intervals: FM- 0.2 MHz
AM - t 0 kHz
For your reference
DVD players can interfere with radio reception. Turn the DVD player
off or move it further away from the antennas if this occurs.
(_Press [TUNER/BAND RECEIVER],
The bandchangeseachtime you pressthebutton.
(_Press [DIRECT TUNING/DISC].
(_)Press the numbered buttons to enter the
frequency.
e.g. To select 107.9 MHz, press [1]_ [0] _ [7]-- [9]
Tuning Intervals: FM - 0.1 MHz
AM- 10 kHz
• If you do not press a buttonwhilethe cursoris flashing,the
displayreturnstothe frequencybeing received.
• If the frequency has not been input correctly, "ERROR" will be
displayed.
(_ Tune to "FM 87,9 MHz".
(_ Press and hold [MEMORY].
TheFM stationstheunitcan receiveare preset in channels1to 30.
(_) Tune to "AM 530 kHz".
(_) Press and hold [MEMORY].
TheAMstationstheunitcanreceiveare presetinchannels21to30.
(FM stationsarereplacedif anywere presetin these channels.)
During automatic presetting, the memory indicator (1_1)flashes and
the frequency scrolls. The memory indicator and channel numbers
are displayed for a second when a station is preset.
The last station to be preset is displayed when presetting finishes.
For your reference
Even if the power supply cord is disconnected from the household
AC outlet, the stations remain in memory for approximately one
month.
Presetthe stationsoneatatime.
(_)Tune to the station.
(_) Press [MEMORY],
(_ Press [TUNING V or A] to select a channel,
(_) Press [MEMORY].
(_ Press [PRESET].
The channel number flashes for about 5 seconds.
(_) Press [TUNING V or A],
Hold down the buttons to change channels faster.
On the remote control
Press [CHANNEL/k or V ].
or
Press the numbered buttons.
For channels 1 to 9, press the corresponding number.
For channels 10 or over, press [_t0/ENTER], then the two digits.
e.g. To select channel 21: [_>10/ENTER] _ [2] _ [1]
g
m
To Next Page
Loading...
