• This schematic diagram may be modified at any time with
the development of new technology..
Notes:
S401 POWER SWITCH (
)
S402 < INPUT SELECT SWITCH
(
)
S403 > INPUT SELECT SWITCH
(
)
S404 ENTER SWITCH (
)
S406 -MENU/-SETUP/RETURN SWITCH
(
)
S407 TUNE- SWITCH (
)
S408 TUNE+ SWITCH (
)
• The voltage value and waveforms are the reference voltage
of this unit measured by DC electronic voltmeter (high
impedance) and oscilloscope on the basis of chassis.
Accordingly, there may arise some error in voltage values
and waveforms depending upon the internal impedance of
the tester or the measuring unit.
• Importance safety notice :
Components identified by
mark have special
characteristics important for safety.
Furthermore, special parts which have purposes of fire-
retardant (resistors), high-quality sound (capacitors), low-
noise (resistors), etc. are used. When replacing any of
components, be sure to use only manufacturer´s specified
parts shown in the parts list.
• In case of AC rated voltage Capacitor, the part no. and
values will be indicated in the Schematic Diagram.
AC rated voltage capacitor:
C701,C703,C704,C705,C706,C714,C732,C736,C737
• Resistor
Unit of resistance is OHM
(K=1000, M=1,000,000).
• Capacitor
Unit of capacitance is
, unless otherwise noted.
F=Farad, pF=Pico Farad.
• Coil
Unit of inductance is H, unless otherwise noted.
• *
FOR INDICATION ONLY.
• Voltage and Signal lines:
: +B signal line
: -B signal line
:Main signal line
:FM / AM signal line
:AUX / Music port signal line
:TV Audio signal line
12 Notes of Schematic Diagram
41
-
45
-
45
To Next Page
Loading...
