5. Load a pre-recorded tape with both side record tabs intact and
close the cassette holder.
6. Press "Tape Play" (After TPS function, tape will stop
automatically).
7. Press "Tape Record".
8. Press "Stop" to indicate Error code.ve).
~ If several problem exist, error code will change each time when
"Stop" is pressed.
(e.g. H01 H03 F01 ..... etc.)
8.3. Clearing all error code
1. Press and hold STOP button for 5 seconds.
2. FL indicator shows “CLEAR” for 1 second and change to “T”.
8.4. Cancelling the Self-Diagnostic mode
1. Press the “Power” button to turn off the system. Press the
“Power” button again to turn on the system.
8.5. Description of error code
8.5.1. Power Amplifier Failure (F61)
When power amplifier output failure for power supply failure.
8.5.2. Error detection for CD Block
Error Code Problem Condition Possible Cause
F15 CD does not function REST SW detection error.
This error occurs when the Optical Pick Up REST SW (S701)
detected within the specified time. (about 8 seconds).
H15 The CD tray closes CD disc tray detect switch NG. (Check and replace)
F26 CD does not function Transmission error between CD servo LSI and micon.
This error occurs between CD servo LSI and micon. This
when the POWER is ON for the CD block and an error is
the transmission has started.
F75 CD power abnormal Under normal operation (self-diagnostic mode inclusive),
CDRST is H for SELECTOR at CD. If it is not H after 1 sec, it
memorised as an error.
8.5.3. Error detection code for Cassette Mechanism Block
19
To Next Page
Loading...
