10
3.2. Replacement of Speaker Connector Housing
3.2.1. Disassembly
Step 1: Use a paper clip push the Speaker Wire head until it
hide inside the Speaker Connector Housing.
Step 2: Pull out the (+) and (-) speaker wires.
3.2.2. Assembly
Step 1: Slightly push up the speaker wire head approximately
45° as shown.
Step 2: Insert the (+) speaker wire into the (+) hole of the
Speaker Connector Housing.
Note: Push in the speaker wire until hear the “click” sound.
Step 3: Insert the (-) speaker wire into the (-) hole of the
speaker connector housing.
Note: Push in the speaker wire until hear the “click” sound.
Step 4: Pull both speaker wires gently to ensure they lock-in
firmly.
Note: Repeat step1 to 3 if the speaker wires come out.
To Next Page
Loading...
