21
8 Disassembly and Assembly Instructions
• This section describes the disassembly and/or assembly procedures for all major printed circuit boards & main compo-
nents for the unit. (You may refer to the section of “Main components and P.C.B Locations” as described in the service
manual)
• Before carrying out the disassembly process, please ensure all the safety precautions & procedures are followed.
• During the disassembly and/or assembly process, please handle with care as there may be chassis components with
sharp edges.
• Avoid touching heatsinks due to its high temperature after prolong use. (See caution as described below)
• During disassembly and assembly, please ensure proper service tools, equipments or jigs is being used.
• During replacement of component parts, please refer to the section of “Replacement Parts List” as described in the ser-
vice manual.
• Select items from the following indexes when disassembly or replacement are required.
• Disassembly of Handle Bar Unit
• Disassembly of Rear Panel
• Disassembly of Amp Unit Block
• Disassembly of Main P.C.B. Assembly
• Disassembly of SMPS Module & Voltage Selector P.C.B.
• Disassembly of Top Panel Unit
• Disassembly of Bluetooth P.C.B. Assembly
• Disassembly of Panel P.C.B.
• Disassembly of FL Display P.C.B.
• Disassembly of Top Front Panel Block
• Disassembly of Tweeter Speaker (6cm)
• Disassembly of Woofer Speaker (10cm)
• Disassembly of Center Front Panel
• Disassembly of Subwoofer Front Panel Block
• Disassembly of Woofer Speaker (25cm)
• Disassembly of Lighting Wire P.C.B. Assembly
To Next Page