Panasonic SC-CMAX5GS

38
Step 18 : Place SMPS Module on support block.
Step 19 : Connect 13P wire at connector (CN2103) on Main
P.C.B. Assembly.
Step 20 : Check SMPS Module, Voltage Selector P.C.B. & Main
P.C.B. Assembly according to the diagram shown.
9.2. Checking of Bluetooth P.C.B.
Assembly, Panel P.C.B. & FL
Display P.C.B.
Step 1 : Remove Handle Bar Unit.
Step 2 : Remove Rear Panel.
Step 3 : Remove Amp Unit Block.
Step 4 : Remove Bluetooth P.C.B. Assembly.
Step 5 : Remove Panel P.C.B..
Step 6 : Remove FL Display P.C.B..
Step 7 : Place Amp Unit Block on support block.
Step 8 : Connect 4P wire at connector (CN2604) on Main
P.C.B. Assembly.
Step 9 : Connect 2P wire at connector (JK3503) on Main P.C.B.
Assembly.
Step 10 : Connect 4P wire at connector (JK3502) on Main
P.C.B. Assembly.