27
8.7. Disassembly of Main P.C.B.
Assembly
• Refer to “Disassembly of Handle Bar Unit”
• Refer to “Disassembly of Rear Panel”
• Refer to “Disassembly of Amp Unit Block”
Step 1 : Remove 4 screws.
Step 2 : Remove Support Plate.
Step 3 : Detach 13P wire at connector (CN2103) on Main
P.C.B. Assembly.
Step 4 : Remove 4 screws.
Step 5 : Remove 1 screw.
Step 6 : Remove Main P.C.B. Assembly.
8.8. Disassembly of SMPS Module
& Voltage Selector P.C.B.
• Refer to “Disassembly of Handle Bar Unit”
• Refer to “Disassembly of Rear Panel”
• Refer to “Disassembly of Amp Unit Block”
• Refer to “Disassembly of Main P.C.B. Assembly”
Step 1 : Remove 4 screws.
Step 2 : Remove Support Plate.
Step 3 : Remove 3 screws.
Step 4 : Release P.C.B. spacers.
Step 5 : Remove SMPS Module and Voltage Selector P.C.B..
To Next Page
Loading...
