Checking the DAB signal quality
To improve reception by adjusting the antenna while monitoring signal
quality on the display.
Press [DAB MENU] to enter menu mode.
“SCAN FAILED” appears if no stations are memorized. If this occurs,
adjust the antenna and try Auto scanning or change the Auto scan
frequency range.
Within 10 seconds, press [ or , ALBUM] to select “SIGNAL
QUALITY” and then press [ENTER].
Press [ or , ALBUM] to select the frequency.
To exit
Press [DAB MENU] again.
In order to enjoy the new stations after adjusting the antenna, it is
necessary to perform Auto scanning and update the station memory.
Note
Note
Frequency block Frequency
Reception quality
0 (poor) - 8 (excellent)
Changing the Auto scan frequency range
Only the frequencies currently used in the UK as of March 2007 on BAND
III are Auto scanned (“United Kingdom”, factory setting).
Select “ALL BAND III” when you want to store stations on other frequencies
to memory.
Press [DAB MENU] to enter menu mode.
Within 10 seconds, press [ or , ALBUM] to select “DAB SCAN
MODE” and then press [ENTER].
Within 10 seconds, press [ or , ALBUM] to select “UNITED
KINGDOM” or “ALL BAND III” and then press [ENTER].
Auto scan begins automatically after the change has been made.
To exit
Press [DAB MENU] again.
When the “DAB SCAN MODE” is changed, the DAB preset channels are
erased and if the DAB play timer has been set the timer switches to off.
To Next Page
Loading...
