Panasonic SC-EN7 - User Manual

8 pages

Save Page as PDF

To Next Page

Dear customer

Thank you for purchasing this product.

Before connecting, operating or adjusting this product, please read these

instructions completely.

Please keep this manual for future reference.

These instructions are applicable to the following systems.

“EB” on the packaging indicates the United Kingdom.

Display

System SC-EN7

Main unit SA-EN7

Speakers SB-EN7

Operating Instructions

CD Stereo System

Model No. SC-EN7

Note

Troubleshooting guide

Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, consult your

dealer for instructions.

No play.

• The disc isn’t correctly set.

• The disc is scratched or dirty. (Tracks skipped.)

• There is moisture on the lens. Wait for about an hour

and then try again.

MP3 cannot be read.

• You may not be able to play MP3 if you have copied a

multi-session disc that has no data between sessions.

• When creating a multi session disc, it is necessary to

close the session.

• The amount of data on the disc is too small. Set the

amount of data to greater than approximately 5 MB.

Sound is unfixed,

reversed or comes

from one speaker only.

• Check the speaker connections. (→ page 2)

No sound or there is a

lot of noise.

• Noise may occur when playing MP3 if recording quality

is poor.

• Keep this unit away from mobile telephones.

• Turn the volume up.

• Switch off the unit, determine and correct the cause,

then switch the unit on. Causes include shorting of the

positive and negative speaker wires, straining of the

speakers through excessive volume or power, and

using the unit in a hot environment.

Humming heard during

play.

• An AC mains lead or fluorescent light is near the

cables. Keep other appliances and cords away from

this unit’s cables.

A beat sound is heard

while receiving a radio

broadcast.

• Turn the TV off or separate it from the unit.

A low hum or noise is

heard during AM

broadcasts.

• Keep the antenna away from other cables and cords.

• Keep the AM antenna away from the unit.

The picture on the

television near the set

disappears or stripes

appear on the screen.

• The location and orientation of the antenna are

incorrect.

• The TV antenna wire is too close to the unit. Separate

the antenna wire of the TV set from the unit.

Remote control

doesn’t work.

• Check that the battery is inserted correctly. (→ page 2)

• Replace the battery if it is worn.

– –:– –

• You plugged the AC adaptor in for the first time or there

was a power failure recently. Set the time. (→ page 5)

• The total programmed play time is more than 200

minutes.

Tracks can still be programmed and played.

PGM FULL

• The number of programmed tracks is limited to 24. No

further tracks can be programmed.

NOT MP3

• A non-CD-DA or non-MP3 CD-ROM disc is inserted.

Cannot be played.

ERROR

• Incorrect operation performed. Read the instructions

and try again.

F76 • There is a power supply problem. Consult the dealer.

Matsushita Electric Industrial Co., Ltd.

Web Site: http://www.panasonic.co.jp/global/

RQT7320-B

H0104ZZ0

GCS

E EB

SC-EN7 (RQT7320-B).fm 1 ページ２００４年１月２７日　火曜日　午前１１時４６分

Questions and Answers

M
Martin TurnerSep 7, 2025
Why does my Panasonic SC-EN7 have no play?
- J
  Joseph ColemanSep 7, 2025
  There might be no play because the disc isn’t correctly set, the disc is scratched or dirty, or there is moisture on the lens. If there is moisture on the lens, wait for about an hour and then try again.
G
Gregory BellAug 22, 2025
Why does my Panasonic Stereo System remote control not work?
- J
  Joan SmithAug 22, 2025
  The remote control might not be working because the battery is not inserted correctly or the battery is worn. Check that the battery is inserted correctly. Replace the battery if it is worn.
C
Cindy AllenSep 4, 2025
How to fix sound that is unfixed, reversed, or only coming from one speaker on my Panasonic SC-EN7 Stereo System?
- B
  brandygloverSep 5, 2025
  If the sound from your Panasonic Stereo System is unfixed, reversed, or only coming from one speaker, check the speaker connections to ensure they are properly connected.
R
ryan48Sep 3, 2025
Why is there no sound or a lot of noise coming from my Panasonic SC-EN7?
- A
  Alejandro KimSep 3, 2025
  If you experience no sound or a lot of noise from your Panasonic Stereo System, especially when playing MP3s, it could be due to poor recording quality of the MP3 file. Also, keep the unit away from mobile telephones. Ensure the volume is turned up. If the issue persists, switch off the unit, determine and correct the cause, then switch the unit on.
A
Andrew MahoneySep 2, 2025
What to do if my Panasonic SC-EN7 Stereo System has a low hum during AM broadcasts?
- G
  George WilliamsSep 2, 2025
  If you hear a low hum or noise during AM broadcasts, keep the antenna away from other cables and cords and keep the AM antenna away from the unit.
M
Monica DavidAug 31, 2025
Why can't my Panasonic SC-EN7 read MP3?
- A
  Antonio JonesSep 1, 2025
  You may not be able to play MP3 if you have copied a multi-session disc that has no data between sessions, or when creating a multi session disc, it is necessary to close the session. Also, set the amount of data to greater than approximately 5 MB, because the amount of data on the disc may be too small.
B
Brenda MillerAug 30, 2025
How to fix unfixed or reversed sound on Panasonic Stereo System?
- D
  danielrileyAug 30, 2025
  If the sound is unfixed, reversed, or only coming from one speaker, check the speaker connections.
T
Teresa SmithAug 29, 2025
Why does my Panasonic SC-EN7 say NOT MP3?
- M
  Mike WilliamsAug 29, 2025
  The 'NOT MP3' message appears when a non-CD-DA or non-MP3 CD-ROM disc is inserted, which cannot be played.
M
mesparzaAug 27, 2025
Why is humming heard during play on my Panasonic Stereo System?
- M
  Melanie JonesAug 28, 2025
  Humming during play may be caused by an AC mains lead or fluorescent light being near the cables. Keep other appliances and cords away from this unit’s cables.
P
Pamela WilliamsAug 27, 2025
What to do if there is no sound or a lot of noise from my Panasonic Stereo System?
- C
  Chelsey SmithAug 27, 2025
  If there is no sound or a lot of noise, it may occur when playing MP3 if recording quality is poor. Keep this unit away from mobile telephones. Also you can turn the volume up. Another solution is to switch off the unit, determine and correct the cause, then switch the unit on.