Panasonic SC-HC49

14
RQT9883
Others
As a factory default, this unit will turn to standby mode
automatically if there is no sound and it is not being
used for approximately 20 minutes.
To cancel this function
1 Press [SETUP] repeatedly to select “AUTO OFF”.
2 Press [3, 4] to select “OFF” and then press [OK].

≥ To turn the function on, select “ON” in step 2.
≥ This setting cannot be selected when “DAB+” ([SC-HC49DB]),
“FM” or “AM” ([SC-HC49] (Australia and New Zealand only)) is
the source.
≥ When connected to a Bluetooth
®
device, the function does
not work.
When “SC-HC49” is selected from a paired Bluetooth
®
device’s Bluetooth
®
menu, this unit will turn on
automatically from standby mode and establish a
Bluetooth
®
connection.
1 Press [SETUP] repeatedly to select “BLUETOOTH
STANDBY”.
2 Press [3, 4] to select “ON” and then press [OK].

≥ To turn the function off, select “OFF” in step 2.
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
2 While pressing and holding [SELECTOR] on the
unit, press and hold [CD/RADIO] on the remote
control until the unit’s display shows “REMOTE 2”.
3 Press and hold [OK] and [CD/RADIO] on the
remote control for at least 4 seconds.

≥ To change the mode back to “REMOTE 1”, press [CD/
RADIO] repeatedly to select “CD” and then repeat the step 2
and 3 but replace [CD/RADIO] with [ ].
Occasionally, Panasonic may release updated
software for this unit that may add or improve the way
a feature operates. These updates are available free of
charge.
For more details, refer to the following website.
http://panasonic.jp/support/global/cs/
(This site is in English only.)
∫ Checking the software version
The version of the installed software is displayed.
Press [SETUP] repeatedly to select “SW VER.” and
then press [OK].
≥ Press [OK] to exit.
Auto off function
Bluetooth
®
standby
Changing the unit and remote
control code
1 Press [CD/RADIO] repeatedly to select “CD”.
Software update
SC-HC49DBGN&GN&GS~RQT9883-B.book 14 ページ ２０１４年２月２１日 金曜日 午前９時２６分