25
RQT7985
The radio
∫ AM frequency step
The step is factory-set to 9 kHz, but you can change it to receive
broadcasts allocated in 10-kHz steps.
1 Press [INPUT SELECTOR] to select “FM”.
2 Press and hold [INPUT SELECTOR].
After a few seconds the display changes to show the current
minimum frequency. Continue to hold the button down. The
minimum frequency changes and the step is changed.
To return to the original step, repeat the above steps.
[Note]
After changing the setting, previously preset frequency will be
cleared. Preset it again.
Use outdoor antennas if radio reception is poor.
≥Disconnect the antenna when the unit is not in use.
≥Do not use the outdoor antenna during an electrical storm.
M
ain unit only
Optional antenna connections
L
R
AU
A
FM ANTFM ANT
AM ANTAM ANT
(7(75≠)
LOOPLOOP
EXTEXT
Leave the AM loop antenna connected.
AM outdoor antenna (Using a vinyl wire)
Run a piece of vinyl wire horizontally across a window or
other convenient location.
5
–1
2m
FM outdoor antenna (Using a television antenna)
≥Disconnect the FM indoor antenna.
≥The antenna should be installed by a competent technician.
75 ≠ coaxial cable
(not included)
HT930GCS.book Page 25 Monday, January 17, 2005 5:14 PM
To Next Page
Loading...
