9
Connecting a paired device
If this sound bar is already connected to a Bluetooth device, press and hold button on the remote
control to disconnect it, the indicator will blink blue quickly, activate your device's Bluetooth function
to search for the Bluetooth signal, select SC-HTB100 on the device list and tap it, when your device
and sound bar is connected the indicator on the sound bar will show a solid blue light.
Disconnecting a device
If this sound bar is connected to a Bluetooth device, press and hold button on the remote control
to disconnect it.
Note: This sound bar can only connect to one device at a time; when the sound bar switches to
Bluetooth mode, it will automatically try to connect to the last connected device; when the sound bar
switches to another source, the previous Bluetooth device will be disconnected.
Remote control
Insert the battery into the remote control. Point the remote control at the remote sensor on the
front panel. The remote control works within a distance of about 8 metres from the sensor and
within an angle of about 30 degrees from the left and right side.
Remove the battery compartment cover on the back of the remote
control.
Load one AAA/1.5V batteries into the battery compartment making
sure that the batteries have been inserted with the correct polarities
matching the symbols +, - as indicated inside the battery
compartment.
To Next Page
Loading...
Need help?
General
